i made a coaster in the haunted senario the coaster in theory should work but when i go to test it, it starts the first climb up the first hill (pulled my a chain) it gets to where the chain ends and just stops dead in its track. but if i disconnect any part of the track it works perfectly. then when i reconnect it, it stops working again. was wondering if any of you guys know a remedy for this.

Could you add more chain to the lift? Perhaps increase the chain speed?

hmm it tried the adding more chains and that did not seem to do anything. also increasing the chain speed did not seem to fix the problem either. i dont know why it does it, it never seem to happen before.

[deleted]