Hello everyone! So, I've been getting to work on my first upload, and I've run into a problem. Correction, a bunch of problems.


The first drop, right out of the station, into a corkscrew and large banked curve



Part of the lift hill


and HERE is where I run into the problem


How should I support this? I'm using CoasterJoe's B&M connectors, but I can't find the right piece. It's a medium curve, banked at a 45 degree angle, with a gentle slope. Is there a piece for that? If not, how would you recommend I go about supporting this?

Any feedback is welcomed. Thanks!

sadly, coaster joes B&M connectors was never a finished set so it is missing a lot of pieces. i just use the 45 degree bank turn connector, its as close as you can get... also, from what i can see in the tiny pictures, your supports are way to spread out. stick with 8H or 12H supports

Thanks for your advice, supermoose! Unfortunately there are enough problems with this track that I'm just going to have to start over. I will fix the (decided) problems in the track, and then I will also change to an H8 or H12 support, as opposed to the current H4 I've been using. Expect something in the near future

EDIT: I kept on changing the layout until I basically ended up with a new coaster So, I present the new and improved (drumroll, please) UNTITLED PROJECT, or, at least, the lift hill of it.


This being my first CS AND first time using a CTR, any help/feedback would be greatly appreciated!